:Best Charger for charging all RC Car, RC Airplane and Airsoft battery packs 12V – 24V. Universal for any NiMH /NiCd battery packs 12V – 24V (10-20 Cells pack).100-240V AC input for worldwide use – 500mA charging current.Designed for use with 12V – 24V battery packs (please don’t charge battery pack under 12V or over 24V).Green LED will flash slowly when no battery is plugged in, Red LED will be on during charging. Green LED will be on when battery is fully charged. Red LED will rapidly flash when the charger is short circuit, Red LED will flash if polarity is reversed or the battery is non-rechargeable.Automatically cut-off by negative delta V detecting or when battery’s temperature is over 60C; when battery pack gets fully charged, Green LED will be on.15-hour safety timer, charger will stop charging after operates 15 hours.One standard Tamiya male connector installed with the charger.One set of alligator clip adapter with female tamiya connector included for charging other type of battery packs.One adapter from standard male Tamiya to mini female Tamiya for charging airsoft gun battery packs.Includes:1 standard Tamiya connector. 1 connector adapter from standard Tamiya to Mini Tamiya. 1 set of alligator clip adapter with standard Tamiya connector on one end. 1 Temperature sensor. Smart Charger SpecificationInputAC100-240VOutput12-24V Dimension119(L) x 61(W) x 38(H)mmWeigh236gOperation InstructionConnect battery pack to output connector and plug AC power source. Make sure battery polarity is connected correctly (Red wire is positive). Put the temperature sensor onto the middle surface of battery pack with rubbberized fabric (refer to the following temperature sensor usage demonstration).When charger is connected to the AC source, the green LED flash.After charger is connected to correct battery pack, the red LED will be on to show that it is charging.Warning:DO NOT operate the charger when temperature is higher than 40C; we recommend you operate when the temperature is lower than 35C due to batteries becomming warm during charge.Highly recommend using Tenergy brand NIMH/NICD battery pack. We are not responsible for any damage caused by charging other brand battery using this charger.Pay attention to battery surface temperature; stop charging when it is over 60C or it feels very hot.Please always use temperature sensor during charge.The charger is designed for indoor use only; don’t leave the charger unattended during charging.The Charger should be positioned horizontally and work in well ventilated condition, avoid water and keep away from flammable explosive goods.Don’t touch the plug. Don’t leave the batteries and chargers on wood surface or carpet.Cut off the power supply before connect or disconnect the charger with batteries. Don’t try to disassemble the charger, High voltage inside, danger! Download product data sheet here.
Click To View Deal